SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1457 (COMPONENT LOCATIONS - ELECTRICAL CENTER IDENTIFICATION VIEWS)ELECTRICAL CENTER IDENTIFICATION VIEWSBODY CONTROL MODULE (BCM) X1
2006 Pontiac G6 GTP, 2D Coupe, Standard

Body Control Module (BCM) X1

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Body Control Module (BCM) X1
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Connector End View
GM1376257Courtesy of GENERAL MOTORS COMPANY
Body Control Module (BCM) X1

Pin Wire Circuit Function
1 - - Not Used
2 0.35 L-GN/BK 592 DRL Relay Control
3 0.35 D-GN/WH 636 Ambient Air Temperature Sensor Signal
4 - - Not Used
5 0.35 WH 5075 Battery Current Sensor Signal
6 0.35 YE 61 Low Reference
7 - - Not Used
8 0.35 BN 5077 Low Reference
9 0.35 BK 350 Ground
10 0.35 PK 5076 5-Volt Low Reference
11 0.35 RD/WH 1940 Battery Positive Voltage
12 0.5 BK 1050 Ground
13 0.35 TN 28 Horn Relay Control
14 - - Not Used
15 0.35 L-BU 2182 Reverse Lamp Relay Control
16 0.35 L-BU 1344 Trunk Release Relay Control
17 - - Not Used
18 0.35 OG/BK 744 Rear Compartment Lid Ajar Switch Signal
19 0.35 YE 317 Fog Lamp Relay Control (T96)
20-21 - - Not Used
22 0.35 D-GN 113 Windshield Wiper Switch Signal 2
23-25 - - Not Used
26 0.35 YE 196 Windshield Wiper Motor Park Switch Signal
27-28 - - Not Used
29 0.35 TN/WH 1969 Headlamp High Beam Relay Control
30-32 - - Not Used
33 0.35 BN/WH 1571 Traction Control Switch Signal
34-36 - - Not Used
37 0.35 D-GN 5060 Low Speed GMLAN Serial Data
38 0.35 L-BU/WH 1314 Left Front Turn Signal Lamp Supply Voltage
39 - - Not Used
40 0.35 D-GN/WH 1135 A/T Shift Lock Control Solenoid Supply Voltage
41 - - Not Used
42 0.35 WH 17 Stop Lamp Switch Signal or Stop Lamp Supply Voltage
43-46 - - Not Used
47 0.35 PU 5357 Right Tail Lamp Outage Detection Signal (1LZ)
48-50 - - Not Used
51 0.35 GY/BK 745 Left Front Door Ajar Switch Signal
52 - - Not Used
53 0.35 L-GN/BK 748 Right Rear Door Ajar Switch Signal
54 0.35 L-BU/BK 747 Left Rear Door Ajar Switch Signal
55 0.35 D-GN 5060 Low Speed GMLAN Serial Data
56 0.35 D-BU/WH 1315 Right Front Turn Signal Lamp Supply Voltage
57 0.35 WH 193 Rear Defog Relay Control
58 0.35 YE 5199 Run/Crank Relay Coil Control
59 0.8 L-BU 1134 Park Brake Switch Signal
60 0.35 PK 849 Brake Fluid Level Sensor Signal
61 - - Not Used
62 0.35 TN/WH 99 Windshield Washer Fluid Level Signal
63 0.35 YE 5356 Left Tail Lamp Outage Detection Signal (1LZ)
64 - - Not Used
65 0.35 WH 1080 Park Lamp Relay Control
66 0.35 WH 682 Door Lock Lock/Unlock Signal
67 0.35 WH 682 Door Lock Lock/Unlock Signal
68 - - Not Used
69 0.35 PK/BK 109 Hood Ajar Switch Signal (AP3)
70 0.35 PU 5531 Hood Ajar Switch Signal (AP3)
71 0.35 BN/WH 2091 Trunk Release Switch Supply Voltage
72 0.35 TN/WH 746 Right Front Door Ajar Switch Signal
Connector Part Information
  • Harness Type: Body
  • OEM Connector: 15393122
  • Service Connector: 88987847
  • Description: 72-Way F Micro-Pack 64 Series (BU) with (GY) Case
Terminal Part Information
  • Pins: 2-3, 5-6, 8-11, 13, 15-16, 18-19, 22, 26, 29, 33, 37-38, 40, 42,, 47, 51, 53-58, 60, 62-63, 65-67, 69-72
  • Terminated Lead: 13575535
  • Release Tool: J-38125-21
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: 15359541/4
  • Core/Insulation Crimp: M/M
  • Pins: 12, 59
  • Terminated Lead: 13579976
  • Release Tool: J-38125-21
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: 15359541/4
  • Core/Insulation Crimp: M/M
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.