SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1446 (ENGINE CONTROLS/FUEL - 2.4L - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSMANIFOLD ABSOLUTE PRESSURE SENSOR REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating MAP Sensor
    GM1889727Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the NEW MAP sensor seal with clean engine oil.
  2. Install the MAP sensor (1) into the intake manifold.
    3. Fig 2: Identifying Fuel Injector Wiring Harness & Connectors
    GM1889726Courtesy of GENERAL MOTORS COMPANY
  3. Connect the fuel injector wiring harness electrical connector (2) to the number 3 fuel injector.
  4. Install the fuel injector wiring harness clips (1) to the fuel rail tabs.
    5. Fig 3: View Of Fuel Injector Wiring Harness Electrical Connector
    GM1889725Courtesy of GENERAL MOTORS COMPANY
  5. Connect the fuel injector wiring harness electrical connector (1) to the MAP sensor.
    6. Fig 4: View Of EVAP Canister Purge Tube
    GM1889722Courtesy of GENERAL MOTORS COMPANY
  6. Position the EVAP canister purge tube (1) out of the way.
  7. Connect the EVAP canister purge tube to the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.