SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1434 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSDOOR LOCK CYLINDER REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Door Lock Cylinder Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Door Lock Cylinder Replacement
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Door Lock Cylinder
GM1564391Courtesy of GENERAL MOTORS COMPANY
Door Lock Cylinder Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the interior trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Remove the outside door handle. Refer to Front Side Door Outside Handle Replacement .
  4. Remove the front side door outside handle housing. Refer to Front Side Door Outside Handle Housing Replacement .
1 Lock Cylinder Clip

Procedure

  1. Disconnect the door lock electrical connector if equipped.
  2. Use a flat-bladed tool to remove the clip.
2 Front Door Lock Cylinder

Procedure

  1. Pull the lock cylinder from the housing to remove.
  2. Inspect the lock, lock cylinder and handle adjustments. Refer to Front Side Door Outside Handle Rod Adjustment .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.