Assembly Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Assembly Procedure
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Flow Control Valve
    GM1776816Courtesy of GENERAL MOTORS COMPANY
  1. Install the power steering pump flow control valve spring (2) into the power steering pump housing (1).
  2. Install the power steering pump flow control valve (3) into the power steering pump housing (1).
  3. Lubricate the power steering pump flow control valve fitting O-ring seal (4) with power steering fluid.
  4. Install the power steering pump flow control valve fitting O-ring seal (4) onto the power steering pump flow control valve fitting (5).
  5. CAUTION:

    Refer to Fastener Caution .

  6. Install the power steering pump flow control valve fitting (5) to the power steering pump housing (1).

    Tighten the fitting to 60 N.m (44 lb ft).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.