Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1417 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B2455CIRCUIT/SYSTEM TESTING
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Testing
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the cellular phone microphone.
- Ignition ON, test for 9.5-10.5 V between the signal circuit terminal B and ground.
- If less than the specified range, test the circuit for a short to ground, shorted together, or an open/high resistance. If the circuit tests normal, replace the vehicle communication interface control module.
- If greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the vehicle communication interface control module.
- Test for 9.5-10.5 V between the signal circuit terminal B and the low reference circuit terminal A.
- If less than the specified range, test the low reference circuit for a short to ground, shorted together, or an open/high resistance. If the circuit tests normal, replace the vehicle communication interface control module.
- If greater than the specified range, test the low reference circuit for a short to voltage. If the circuit tests normal, replace the vehicle communication interface control module.
- If all circuit test normal, replace the cellular phone microphone.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.