Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1302 (ENGINE CONTROLS AND FUEL - 2.4L - DTC P0010 TO DTC P0366)DTC P0230CIRCUIT/SYSTEM TESTING
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Testing
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the fuel pump relay using the J 43244: Pliers.
- Ignition ON, verify that a test lamp illuminates between the ground circuit terminal 85 and B+.
- If the test lamp does not illuminate, test the ground circuit for a short to voltage or an open/high resistance.
- Verify that a test lamp does not illuminate between the ground circuit terminal 85 and the control circuit terminal 86.
- If the test lamp illuminates, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
- Remove the test lamp.
- Command the fuel pump relay ON with a scan tool. Verify the scan tool Fuel Pump Relay Ckt Short Gnd Test Status parameter is OK.
- If not the specified value, test the fuel pump relay control circuit for a short to ground. If the circuit tests normal, replace the ECM.
- Install a 3 A fused jumper wire between the fuel pump relay control circuit terminal 86 and the ground circuit terminal 85. Command the fuel pump relay ON with a scan tool. Verify the scan tool Fuel Pump Relay Ckt Short Gnd Test Status parameter is Fault.
- If not the specified value, test the fuel pump relay control circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the fuel pump relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.