Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1248 (FRONT SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Pontiac G6 GTP, 2D Coupe, Standard
Fastener Tightening Specifications
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Ball Stud to Steering Knuckle Nut | ||
|
50 N.m Reverse nut 3/4 turn |
37 lb ft Reverse nut 3/4 turn |
|
50 N.m + 30° | 37 lb ft +30° |
| Frame Support Bracket to Body Bolt | 100 N.m | 74 lb ft |
| Hub and Bearing Assembly Bolts | 115 N.m | 85 lb ft |
| Lower Control Arm Bushing to Frame Bolts | ||
|
50 N.m | 37 lb ft |
|
+90° | |
| Lower Control Arm to Bushing Bolt | 44 N.m | 32 lb ft |
| Outer Tie Rod to Steering Knuckle Nut | ||
|
20 N.m | 15 lb ft |
|
+180° | |
|
50 N.m | 37 lb ft |
| Rear Frame to Body Bolts | ||
|
100 N.m | 74 lb ft |
|
+90° | |
| Stabilizer Link Nut | 65 N.m | 48 lb ft |
| Stabilizer Shaft Clamp Bolts | 25 N.m | 18 lb ft |
| Steering Knuckle to Strut Bolts and Nuts | 120 N.m | 89 lb ft |
| Upper Strut Cap to Body Nuts | 25 N.m | 18 lb ft |
| Upper Strut Shaft Nut | 70 N.m | 52 lb ft |
| Wheel Drive Shaft Nut | 215 N.m | 159 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.