SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1233 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR REPLACEMENT (LE5)INSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Generator Fasteners
    GM2094845Courtesy of GENERAL MOTORS CORP.
  1. Position the generator to the engine block.
  2. Install the generator fasteners (4) loosely.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the fastener (1) and tighten to 10 N.m (89 lb in).
  4. Install the fastener (3) and tighten to 22 N.m (16 lb ft).
  5. Tighten the fasteners (4) to 22 N.m (16 lb ft).
    6. Fig 2: View Of Generator Electrical Connectors
    GM1578426Courtesy of GENERAL MOTORS CORP.
  6. Install the engine harness terminal (4) to the generator stud.
  7. Install the engine harness terminal lead to generator nut (2) and tighten to 20 N.m (15 lb ft).
  8. Position the rubber boot (3) over the stud.
  9. Connect the generator electrical connector (1).
  10. Install the drive belt. Refer to Drive Belt Replacement (LE5) .
  11. Connect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LE5, LE9, LZ4, LZE, or LY7) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.