SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1230 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSFRONT FOG LAMP REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Front Fog Lamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Front Fog Lamp Replacement
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Fog Lamp Assembly
GM1675199Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to Fastener Caution .

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove either the LF or RF front wheelhouse splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .
  3. Disconnect fog lamp bulb socket electrical connector.
1 Front Fog Lamp Adjuster Screw
  1. Remove the adjuster screw from the fog lamp bracket and lamp assembly.
  2. Count the number of turns when removing the adjuster screw for a reference upon installation.
  3. Aim the fog lamp after installation. Refer to Fog Lamp Aiming .
2 Front Fog Lamp Screws (Qty: 2)

Tighten:  2 N.m (18 lb in)
3 Front Fog Lamp Assembly
Tip:  Remove the lamp assembly from the fog lamp bracket.
4 Front Fog Lamp Bulb
WARNING: Refer to Halogen Bulb Warning .

Tip:  Turn the bulb socket counter clockwise and remove from lamp assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.