Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1230 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSBACKUP LAMP REPLACEMENT

2006 Pontiac G6 GTP, 2D Coupe, Standard

Backup Lamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Backup Lamp Replacement

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Backup Lamp

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Procedure

Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .
Disconnect the electrical harness connector from the backup lamp socket.

Back Up Lamp Nut (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 5 N.m (44 lb in)

Back Up Lamp Assembly

Procedure

WARNING: Refer to Glass and Sheet Metal Handling Warning .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.