Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1200 (CRUISE CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0572 OR P0573CIRCUIT/SYSTEM TESTING
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Testing
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connectors at the modules listed below.
- ECM X1
- TCM
- Connect a test lamp between the appropriate signal circuit terminal listed below and ground.
- TCM terminal 16 (MH2)
- TCM terminal 42 (ME7 or MN5)
- Ignition ON, press and release the brake pedal. Verify the test lamp turns ON and OFF when pressing and releasing the brake pedal.
- If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
- If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- Ignition OFF, connect the harness connector at the TCM.
- Connect a test lamp between the appropriate signal circuit terminal listed below and ground.
- ECM terminal 9 X1 (LZ4)
- ECM terminal 7 X1 (LAT or LYZ)
- Ignition ON, press and release the brake pedal. Verify the test lamp turns ON and OFF when pressing and releasing the brake pedal.
- If the test lamp is always OFF, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
- If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the TCM.
- If all circuit tests normal, replace the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.