SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1134 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNT STOP LAMP REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

High Mount Stop Lamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION High Mount Stop Lamp Replacement
WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying High Mount Stop Lamp
GM1999266Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the rear window shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement .
  2. Disengage the rear window shelf insulator from the rear shelf trim panel in order to access the high mount stop lamp screws.
  3. Disconnect the electrical connector at the high mount stop lamp.
1 High Mount Stop Lamp Screw (Qty: 3)
Tip:  Hand tighten only, no torque required.
2 High Mount Stop Lamp Assembly
Tip:  The lamp is (LED) Light Emitting Diode and is serviced as an assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.