SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1134 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE TURN SIGNAL LAMP REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Front Side Turn Signal Lamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Front Side Turn Signal Lamp Replacement
WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Side Marker Lamp Bulb
GM1988127Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

    NOTE: Refer to Exterior Trim Emblem Removal Notice .
  1. Remove the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .
  2. Disconnect the front turn signal lamp electrical connector from the forward lamp harness assembly at the topside of the fender panel.
  3. Rotate the lamp socket from the lamp housing.
  4. Squeeze the lamp housing locking tab and push outward in order to remove the lamp housing from the fender panel.
1 Front Turn Signal Lamp Assembly
Tip:  Replace the bulb, as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.