SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1133 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT STEERING WHEEL MODULE COIL REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Inflatable Restraint Steering Wheel Module Coil Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Inflatable Restraint Steering Wheel Module Coil Replacement
WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Inflatable Restraint Steering Wheel Module Coil
GM1998552Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
1 Inflatable Restraint Steering Wheel Module Coil Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  1.5 N.m (13 lb in)
2 Inflatable Restraint Steering Wheel Module Coil
Procedure: 
Disconnect any electrical connectors as needed.

Tips

  • Do not remove the centering tab from a new inflatable restraint steering wheel module coil until it has been installed or re-centering will be required.
  • If re-centering of the inflatable restraint steering wheel module coil is needed then refer to Inflatable Restraint Steering Wheel Module Coil Centering .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.