SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1088 (SUSPENSION CONTROL SYSTEM - AUTOMATIC LEVEL CONTROL)REPAIR INSTRUCTIONSAIR TUBE REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Harness Tie & Bolts From Air Compressor Bracket & Air Tube From Air Dryer
    GM227996Courtesy of GENERAL MOTORS CORP.
  1. Connect the air tube to the air dryer.
    2. NOTE: Refer to Fastener Notice .
  2. Install the air tube with the harness tie and the bolt on the air compressor bracket.
    3. Fig 2: Identifying Air Tubes Connected To Shock Absorbers
    GM517949Courtesy of GENERAL MOTORS CORP.
  3. Install the air tube on the vehicle with 3 clips.
  4. Connect the air tube to the left and right rear shock absorbers.
  5. Install 2 metal clips on the air tube and the vehicle. Place each clip immediately forward of the wheel house fold-over tabs on the LH and RH side of the vehicle.
  6. Install both rear wheels. Refer to Tire and Wheel Removal and Installation .
    7. IMPORTANT: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.
  7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.