Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1082 (COMPONENT LOCATIONS)POWERTRAIN COMPONENT VIEWS
2006 Pontiac G6 GTP, 2D Coupe, Standard
Powertrain Component Views
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Powertrain Component Views
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emission (EVAP) Canister Purge Solenoid Valve |
| 2 | Exhaust Gas Recirculation (EGR) Valve |
| Callout | Component Name |
|---|---|
| 1 | Heated Oxygen Sensor (HO2S) 2 |
| Callout | Component Name |
|---|---|
| 1 | Secondary Air Injection (AIR) Pump |
| Callout | Component Name |
|---|---|
| 1 | Pressure Control (PC) Solenoid Valve Assembly |
| 2 | 1-2, 3-4 Shift Solenoid (SS) Valve Assembly |
| 3 | Automatic Transmission Input Shaft Speed (A/T ISS) Sensor Assembly |
| 4 | 2-3 Shift Solenoid (SS) Valve Assembly |
| 5 | Lever Assembly-Manual Shaft Detent with Shift Position Switch - Internal Mode Switch (IMS) |
| 6 | Vehicle Speed Sensor (VSS) Assembly |
| 7 | Transmission Fluid Pressure (TFP) Manual Valve Position Switch Assembly |
| 8 | Transmission Fluid Temperature (TFT) Sensor |
| 9 | Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid Valve Assembly |
| Callout | Component Name |
|---|---|
| 1 | Secondary Air Injection (AIR) Check Valve (NU6) |
| Callout | Component Name |
|---|---|
| 1 | Mass Air Flow (MAF) / Intake Air Temperature (IAT) Sensor |
| 2 | Engine Control Module (ECM) (LD8/L37), Powertrain Control Module (PCM) (L26), in the Air Cleaner Assembly |
| Callout | Component Name |
|---|---|
| 1 | Ignition Coil Module |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Fuel Injector 1 |
| 4 | Fuel Injector 3 |
| 5 | Fuel Injector 5 |
| 6 | Exhaust Gas Recirculation (EGR) Valve |
| 7 | Throttle Actuator Control (TAC) Module |
| 8 | Engine Coolant Temperature (ECT) Sensor |
| 9 | Starter Solenoid |
| 10 | Starter |
| 11 | Engine Oil Level Switch |
| 12 | G110 |
| 13 | Knock Sensor (KS) 1 |
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emission (EVAP) Canister Purge Solenoid Valve |
| 2 | Throttle Actuator Control (TAC) Module |
| 3 | Exhaust Gas Recirculation (EGR) Valve |
| 4 | Fuel Injector 6 |
| 5 | Fuel Injector 4 |
| 6 | Fuel Injector 2 |
| 7 | Manifold Absolute Pressure (MAP) Sensor |
| 8 | Camshaft Position (CMP) Sensor |
| 9 | Engine Oil Pressure (EOP) Sensor |
| 10 | Knock Sensor (KS) 2 |
| 11 | Heated Oxygen Sensor (HO2S) 1 |
| Callout | Component Name |
|---|---|
| 1 | Torque Converter Clutch Pulse Width Modulated (TCC PWM) Solenoid Valve |
| 2 | Pressure Control Solenoid (PCS) Valve |
| 3 | Automatic Transmission Input (Shaft) Speed Sensor (ISS) |
| 4 | Vehicle Speed Sensor (VSS) |
| 5 | 1-2 and 2-3 Shift Solenoid (1-2 SS) (2-3 SS) Valves |
| 6 | Internal Mode Switch (IMS) |
| 7 | Automatic Transmission Fluid Temperature (TFT) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Starter Motor |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Throttle Body Assembly |
| 4 | Fuel Injector 8 |
| 5 | Ignition Coil/Module 8 |
| 6 | Fuel Injector 6 |
| 7 | Ignition Coil/Module 6 |
| 8 | Knock Sensor (KS) 2 |
| 9 | Fuel Injector 4 |
| 10 | Ignition Coil/Module 4 |
| 11 | Ignition Coil/Module 2 |
| 12 | Fuel Injector 2 |
| 13 | Crankshaft Position (CKP) Sensor |
| 14 | Knock Sensor (KS) 1 |
| 15 | Camshaft Position (CMP) Sensor |
| 16 | Ignition Coil/Module 1 |
| 17 | Ignition Coil/Module 3 |
| 18 | Fuel Injector 1 |
| 19 | Ignition Coil/Module 5 |
| 20 | Fuel Injector 3 |
| 21 | Ignition Coil/Module 7 |
| 22 | Fuel Injector 5 |
| 23 | Fuel Injector 7 |
| Callout | Component Name |
|---|---|
| 1 | Valve Cover |
| 2 | Ignition Coil/Module 2 |
| 3 | Ignition Coil/Module 4 |
| 4 | Ignition Coil/Module 6 |
| 5 | Ignition Coil/Module 8 |
| 6 | Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1 |
| 7 | Engine Oil Pressure (EOP) Switch |
| Callout | Component Name |
|---|---|
| 1 | Throttle Body Assembly |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Valve Cover |
| 4 | Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1 |
| 5 | Engine Coolant Temperature (ECT) Sensor |
| 6 | Heated Oxygen Sensor (HO2S) Bank 2 Sensor 2 |
| Callout | Component Name |
|---|---|
| 1 | Engine - 4.6L |
| 2 | A/C Compressor Clutch |
| 3 | Generator |
| 4 | G110 |
| Callout | Component Name |
|---|---|
| 1 | Exhaust Manifold |
| 2 | G114 |
| 3 | G112 |
| 4 | G115 |
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emission (EVAP) Canister Purge Solenoid Valve |
| 2 | Intake Manifold |
| 3 | Vehicle Speed Sensor (VSS) |
| 4 | Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1 |
| 5 | G114 |
| 6 | Transmission |
| Callout | Component Name |
|---|---|
| 1 | Exhaust Gas Recirculation (EGR) Valve |
| 2 | Valve Cover |
| 3 | G100 |
| 4 | Engine Coolant Temperature (ECT) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Generator |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Throttle Actuator Control (TAC) Module |
| 4 | Engine Coolant Heater |
| 5 | Starter |
| 6 | Knock Sensor (KS) 1 |
| 7 | Engine Oil Level Switch |
| 8 | A/C Compressor Clutch |
| 9 | Ignition Control Module (ICM) |
| Callout | Component Name |
|---|---|
| 1 | Exhaust Gas Recirculation (EGR) Valve |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Throttle Actuator Control (TAC) Module |
| 4 | Ignition Coil / Module |
| 5 | Crankshaft Position (CKP) Sensor |
| 6 | Engine Oil Pressure (EOP) Sensor |
| 7 | Camshaft Position (CMP) Sensor |
| 8 | Heated Oxygen Sensor (HO2S) 1 |
| Callout | Component Name |
|---|---|
| 1 | Intake Manifold |
| 2 | Ignition Control Module |
| 3 | G115 |
| 4 | Harmonic Balancer |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.