Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (AUTOMATIC TRANSAXLE - INTRODUCTION & REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSOUTPUT SHAFT REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Installation Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the drive axle retainer rings (509) to the output shaft (510).
- Hold the front differential carrier in place and carefully install the output shaft (510) to the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
- Install the case extension housing. Refer to Case Extension Housing Replacement .
- Install the left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.