SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1069 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSHEADLAMP SWITCH
2006 Pontiac G6 GTP, 2D Coupe, Standard

Headlamp Switch

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Headlamp Switch
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp Switch Connector End View
GM850856Courtesy of GENERAL MOTORS CORP.
Headlamp Switch

Pin Wire Circuit Function
1 0.35 WH 103 Headlamp Switch Headlamps On Signal
2 0.35 L-BU/TN 13 Park Lamp Switch ON Signal
3 0.35 D-GN 306 Headlamp Switch OFF Signal
4-5 - - Not Used
6 0.35 OG 192 Front Fog Lamp Switch Signal (T96)
7 0.35 GY 8 Instrument Panel Lamp Supply Voltage
8 0.35 BK 450 Ground
9 0.35 OG 900 Lane Departure Warning On Signal (UFL)
10 0.35 L-BU 383 Trunk Release Control
11 0.35 PU/WH 1382 LED Dimming Signal
12 0.35 PK/BK 1597 Courtesy Lamp Switch On Signal
13 0.35 PK 1444 I/P Dimming Signal
14 - - Not Used
15 0.5 OG/WH 812 12-Volt Reference
16 0.35 OG 901 Lane Departure Warning Control (UFL)
Connector Part Information 
  • OEM: 15416970
  • Service: 22715969
  • Description: 16-Way F Micro-Pack 64 Series (BK)
Terminal Part Information 
  • Terminal/Tray: 15359541/4
  • Core/Insulation Crimp: M/M
  • Release Tool/Test Probe: 15381651-2/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.