SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1069 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSHVAC CONTROL MODULE X2 (C67)
2006 Pontiac G6 GTP, 2D Coupe, Standard

HVAC Control Module X2 (C67)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION HVAC Control Module X2 (C67)
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: HVAC Control Module X2 (C67) Connector End View
GM1664586Courtesy of GENERAL MOTORS CORP.
HVAC Control Module X2 (C67)

Pin Wire Circuit Function
1 0.35 PU/WH 1382 LED Dimming Signal
2 0.35 YE 1491 Backlight Lamp Control
3 0.35 YE/WH 1318 Lower Mode Door Control B
4 0.35 L-BU/YE 1199 Air Temperature Door Control
5-6 - - Not Used
7 0.35 WH 2622 Evaporator Low Temperature Sensor Signal
8 0.35 L-GN/BK 735 Ambient Air Temperature Sensor Signal
9-10 - - Not Used
11 0.35 TN 2273 Mode Door Control A
12 0.35 YE/GY 1791 Low Reference
13 - - Not Used
14 0.35 L-BU 733 Air Temperature Door Position Signal
15 0.35 YE/BK 1814 Lower Mode Door Position Signal
16 - - Not Used
Connector Part Information 
  • OEM: 7283-9081
  • Service: See Catalog
  • Description: 16-Way F (WH)
Terminal Part Information 
  • Terminal/Tray: 7116-4618-02/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.