SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1069 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) X2
2006 Pontiac G6 GTP, 2D Coupe, Standard

Body Control Module (BCM) X2

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Body Control Module (BCM) X2
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) X2 Connector End View
GM1664496Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) X2

Pin Wire Circuit Function
1 0.8 OG 1732 12-Volt Reference
2 0.8 PK/D-BU 3140 Battery Positive Voltage
3 0.8 GY 8 Instrument Panel Lamp Supply Voltage
4 - - Not Used
5 0.8 GY/BK 690 Courtesy Lamp Relay Control
6-7 - - Not Used
8 0.35 L-BU/TN 13 Park Lamp Switch ON Signal
9 - - Not Used
10 0.35 L-BU 383 Trunk Release Control
11 0.35 L-GN/BK 1137 Ambient Light Sensor Signal
12 0.35 WH 103 Headlamp Switch Off Signal
13-16 - - Not Used
17 0.35 D-GN 306 Park Lamp Switch ON Signal
18 0.35 PK/BK 1597 Courtesy Lamp Switch On Signal
19-20 - - Not Used
21 0.35 BN/WH 1571 Traction Control Switch Signal
22 0.35 PU 6027 Brake Transmission Shift Interlock Solenoid Control (A51)
23-25 - - Not Used
Connector Part Information 
  • OEM: HITPB-25-B-S
  • Service: See Catalog
  • Description: 25-Way F (WH)
Terminal Part Information 
  • Pins: 1-3
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094429/J-35616-4A (PU)
  • Pins: 8, 10-12, 17, 18, 21, 22
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: 12094429/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.