SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1069 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSAUTOMATIC LEVEL CONTROL MODULE (FE1/FE3/F41)
2006 Pontiac G6 GTP, 2D Coupe, Standard

Automatic Level Control Module (FE1/FE3/F41)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Automatic Level Control Module (FE1/FE3/F41)
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Automatic Level Control Module (FE1/FE3/F41) Connector End View
GM632344Courtesy of GENERAL MOTORS CORP.
Automatic Level Control Module (FE1/FE3/F41)

Pin Wire Circuit Function
A 0.35 WH 320 Automatic Level Control Exhaust Solenoid Control
B - - Not Used
C 0.5 BK 850 Ground
D 0.35 TN/BK 2500 High Speed GMLAN Serial Data Bus +
E 0.5 RD/WH 3340 Battery Positive Voltage
F 0.35 YE 321 Automatic Level Control Relay Control
G 0.35 TN 2501 High Speed GMLAN Serial Data Bus-
H 0.5 TN 2501 High Speed GMLAN Serial Data Bus-
J 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus +
K 0.35 OG/YE 5727 High Speed GMLAN Serial Data Wake Up
Connector Part Information 
  • OEM: 15326842
  • Service: 15326842
  • Description: 10-Way F 150 Series Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: 12191819/8
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 15315247/J-35616-2A (GY)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.