Diagnostic Code Index

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Diagnostic Code Index
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX

DTC Description
DTC C0035-C0050  C0035 00: Left Front Wheel Speed Sensor Circuit Open or Shorted Signal
C0035 0F: Left Front Wheel Speed Sensor Circuit Erratic Signal
C0035 18: Left Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
C0040 00: Right Front Wheel Speed Sensor Circuit Open or Shorted Signal
C0040 0F: Right Front Wheel Speed Sensor Circuit Erratic Signal
C0040 18: Right Front Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
C0045 00: Left Rear Wheel Speed Sensor Circuit Open or Shorted Signal
C0045 0F: Left Rear Wheel Speed Sensor Circuit Erratic Signal
C0045 18: Left Rear Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
C0050 00: Right Rear Wheel Speed Sensor Circuit Open or Shorted Signal
C0050 0F: Right Rear Wheel Speed Sensor Circuit Erratic Signal
C0050 18: Right Rear Wheel Speed Sensor Circuit Signal Amplitude Less Than Minimum
DTC C0110  C0110 04: Pump Motor Circuit Open Circuit
C0110 61: Pump Motor Circuit Actuator Stuck
DTC C0131  C0131 00: ABS Pressure Circuit
DTC C0161  C0161 00: TCS Brake Switch Circuit
DTC C0179  C0179 00: System Thermal High
DTC C0186  C0186 00: Lateral Accelerometer Circuit
DTC C0196  C0196 00: Yaw Rate Circuit No Additional Information
C0196 28: Yaw Rate Circuit Incorrect Frequency
DTC C0201  C0201 00: Antilock Brake System (ABS) Enable Relay Contact Circuit
DTC C0242 or P0856  C0242 00: Engine Control Module (ECM) Indicated TCS Malfunction
P0856: Traction Control Torque Request Circuit
DTC C0245  C0245 00: Wheel Speed Sensor Frequency Error
DTC C0292  C0292 00: VSES Combination Sensor Circuits
DTC C0558  C0558 46: Calibration Data Not Programmed/Learned, vehicle configuration not programmed
DTC C0561  C0561 71: System Disabled Information Stored Invalid Serial Data Received
DTC C0710  C0710 00: Steering Position Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.