Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1052 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Installation Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
When installing the negative battery cable, ensure that the cable eyelet is installed with the flat side down. Keep the crimped side facing upward.
- Place the negative battery cable eyelet over the hole in the floor pan.
- Install the negative battery cable ground bolt.
Tighten: Tighten the bolt to 36 N.m (27 lb ft).
- Connect the body harness electrical connector to the battery current sensor.
- Connect the body harness electrical connector to the negative battery cable electrical connector.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.