Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1044 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B2470CIRCUIT/SYSTEM TESTING
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Testing
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the cellular antenna coax from the CIM module and the cellular antenna.
- Ignition ON, test for less than 1 volt between the antenna coax center terminal and ground.
- If greater than the specified range, replace the antenna coax.
- Ignition ON, test for less than 1 volt between the antenna coax outer shield and ground.
- If greater than the specified range, replace the antenna coax.
- Test for infinite resistance between the antenna coax center terminal and ground.
- If less than the specified value, replace the antenna coax
- Test for infinite resistance between the antenna coax outer shield and ground.
- If less than the specified value, replace the antenna coax
- Test for less than 5 ohms at the cellular antenna coax center terminal from end to end.
- If greater than specified value, replace the cellular antenna coax cable.
- Test for less than 5 ohms at the cellular antenna coax outer shield from end to end.
- If greater than specified value, replace the cellular antenna coax cable.
- Test for infinite resistance between the antenna coax center terminal and the outer shield.
- If less than specified value, replace the cellular antenna coax cable.
- If coax cable tests normal, replace the cellular antenna.
- Clear the DTCs and operate the vehicle within the conditions for running the DTC. Verify DTC B2470 does not set.
- If the DTC sets, replace the CIM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.