Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1037 (INTERIOR TRIM AND PANELING)
2006 Pontiac G6 GTP, 2D Coupe, Standard
Section 1037 (Interior Trim And Paneling)
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Section 1037 (Interior Trim And Paneling)
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Front Side Door Trim Panel Replacement
- Rear Side Door Trim Panel Replacement
- Front Side Door Water Deflector Replacement
- Rear Side Door Water Deflector Replacement
- Body Hinge Pillar Trim Panel Replacement
- Rear Compartment Trim Panel Replacement
- Assist Handle Replacement
- Coat Hook Replacement
- Sunshade Replacement
- Sunshade Retainer Bezel Replacement
- Windshield Pillar Garnish Molding Replacement
- Center Pillar Upper Garnish Molding Replacement
- Center Pillar Lower Garnish Molding Replacement
- Quarter Upper Trim Panel Replacement
- Rear Window Shelf Trim Panel Replacement
- Rear Shelf Trim Panel Carrier Replacement
- Rear Compartment Sill Trim Plate Replacement
- Rear Compartment Lid Inner Panel Trim Replacement
- Front Floor Console Cup Holder Replacement
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.