Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1036 (FIXED & MOVEABLE WINDOW SYSTEMS)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Pontiac G6 GTP, 2D Coupe, Standard
Fastener Tightening Specifications
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Door Outer Belt Sealing Strip Screws | 2 N.m | 18 lb in |
| Front Door Window Bolts | 4.6 N.m | 41 lb in |
| Front Door Window Channel Retaining Screws | 2 N.m | 18 lb in |
| Front Door Window Outside Belt Molding Screws | 1.3 N.m | 12 lb in |
| Front Door Window Regulator Bolts | 10 N.m | 89 lb in |
| Front Door Window Regulator Screws | 10 N.m | 89 lb in |
| Front Door Window Regulator Motor Bolts | 4.6 N.m | 41 lb in |
| Rear Door Outer Belt Sealing Strip Screws | 2 N.m | 18 lb in |
| Rear Door Stationary Window Bolts | 10 N.m | 89 lb in |
| Rear Door Window Bolts | 10 N.m | 89 lb in |
| Rear Door Window Regulator Bolts | 10 N.m | 89 lb in |
| Rear Door Window Regulator Motor Bolts | 4.6 N.m | 41 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.