SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1027 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Steering Wheel Control Switch Assembly Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Steering Wheel Control Switch Assembly Replacement
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel Control Switch Assembly Replacement
GM1537927Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Preliminary Procedure: Remove the steering wheel inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
Radio Control Switch Replacement - Left 
1 Screws, Steering Wheel Cover (Qty: 2)

Tighten:  2 N.m (18 lb in)
2 Cover, Steering Wheel
3 Switch Assembly, Radio Controls
Tip: 
  1. Disconnect the electrical connector.
  2. Use a small flat-bladed tool to remove the switch from the cover.
Radio Control Switch Replacement - Right 
4 Screws, Steering Wheel Cover (Qty: 2)

Tighten:  2 N.m (18 lb in)
5 Cover, Steering Wheel
6 Switch Assembly, Radio Controls
Tip: 
  1. Disconnect the electrical connector.
  2. Use a small flat-bladed tool to remove the switch from the cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.