Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1024 (CRUISE CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0567CIRCUIT/SYSTEM TESTING
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Testing
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, verify that the Cruise Resume/Accel. Switch parameter reads Active or Invalid.
- If the parameter reads Inactive, go to Diagnostic Aids.
- Ignition OFF, disconnect the harness connector at the cruise control switch.
- Ignition ON, cruise control switch ON, observe the scan tool Cruise Resume/Accel. Switch parameter.
- If the scan tool parameter reads Inactive, replace the cruise control switch assembly.
- If the scan tool parameter reads Active or Invalid, test the cruise control switch signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.