SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1020 (SHIFT INTERLOCK SYSTEM)REPAIR INSTRUCTIONSAUTOMATIC TRANSMISSION SHIFT LOCK ACTUATOR REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Shift Lock Actuator Electrical Connector
    GM1538451Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lock actuator (2) to the linear shift assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Install the shift lock actuator screws (3).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Connect the shift lock actuator electrical connector (1).
    4. Fig 2: Identifying Linear Shift Assembly Bolt/Holes
    GM1538450Courtesy of GENERAL MOTORS CORP.
  4. Rotate the linear shift assembly (2) up to align the linear shift assembly bolt holes.
    5. Fig 3: View Of Shift Lock Actuator Linear Shift Front Bolts
    GM1538449Courtesy of GENERAL MOTORS CORP.
  5. Install the linear shift front bolts (2).

    Tighten:  Tighten the bolts (1, 2) to 10 N.m (89 lb in).

  6. Install the steering column. Refer to Steering Column Replacement .
  7. Install the trim covers to the steering column. Refer to Steering Column Trim Covers Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.