Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1015 (ACCESSORY POWER SOCKET)REPAIR INSTRUCTIONSAC/DC POWER OUTLET CONTROL MODULE REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard
AC/DC Power Outlet Control Module Replacement
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION AC/DC Power Outlet Control Module Replacement
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
AC/DC Power Outlet Control Module Replacement
| Callout | Component Name |
|---|---|
| 1 | Inflator Air Valve Opening Cover Refer to Inflator Air Valve Opening Cover Replacement . |
| 2 | AC/DC Power Outlet Control Module Bracket Nuts (Qty: 3)
NOTE:
Refer to Fastener Notice
.
Tighten: 10 N.m (89 lb in) |
| 3 | AC/DC Power Outlet Control Module Bracket Bolt/Screw Tighten: 10 N.m (89 lb in) |
| 4 | AC/DC Power Outlet Control Module Bolt/Screw Tighten: 2.5 N.m (23 lb in) |
| 5 | AC/DC Power Outlet Control Module Refer to Control Module References for programming and setup information. Tip: Disconnect the electrical connectors. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.