SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1003 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSGARAGE DOOR OPENER REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Overhead Console Components
    GM1530702Courtesy of GENERAL MOTORS CORP.
  1. Position the garage door opener (2) to the overhead console.
    2. NOTE: Refer to Fastener Notice .
  2. Install the screws to secure the garage door opener (2) to the overhead console.

    Tighten:  Tighten the nuts to 2 N.m (18 lb in).

    3. Fig 2: View Of Overhead Console Mounting
    GM1530697Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connectors.
  4. Align the overhead console within the vehicle.
  5. Press up on the overhead console engaging the fasteners in order to secure the console to the vehicle.
  6. Install the overhead console mounting screw.

    Tighten:  Tighten to 2 N.m (18 lb in).

  7. Install the courtesy lamp lens.
  8. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.