Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1003 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)DIAGNOSTIC INFORMATION AND PROCEDURESREMOTE VEHICLE START INOPERATIVECIRCUIT/SYSTEM VERIFICATION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Verification
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that RVS is enabled in the vehicle driver information center (DIC).
- If RVS is not enabled, use the DIC to turn on RVS functionality.
- Verify that the keyless entry functions operate with all available keyless entry transmitters.
- If the keyless entry system does not function properly with all available transmitters, refer to Keyless Entry System Inoperative .
- With a scan tool, verify that no RVS Disable History is present.
- If RVS disable history is present, refer to the applicable subsection in which the failure occurred.
- With a scan tool, verify that there are no Current CTD Triggers present.
- If a CTD trigger exists, refer to Content Theft Deterrent (CTD) Alarm Mode Inoperative .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.