Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1003 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)DIAGNOSTIC INFORMATION AND PROCEDURESGARAGE DOOR OPENER INOPERATIVECIRCUIT/SYSTEM TESTING
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Testing
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, valet switch OFF, if equipped. Press each button of the GDO one at a time. The LED on the GDO should illuminate with each button pressed.
- If none of the buttons respond, test the battery positive voltage circuit and the ground circuit for an open/high resistance. If the circuits test normal, replace the GDO.
- Ignition ON, hold the 2 outer buttons on the GDO until the LED on the GDO stops flashing. Place the J 41540
adjacent to the GDO and press each button of the GDO one at a time. The tester should indicate when each button is pressed.
- If the tester indicates that one or more of the buttons does not respond, replace the GDO.
- Program the GDO with the customers remote. A possible rolling code or incompatibility with the GDO receiver will prevent programming. Refer to Homelink at 1-800-355-3515.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.