Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSSIR DISABLING AND ENABLING ZONE 2DISABLING PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Disabling Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Disabling Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the steering wheel so that the vehicle wheels are pointing straight ahead.
- Turn the ignition switch to the OFF position.
- Remove the key from the ignition switch.
- Locate the body control module fuse center then remove fuse center cover.
- Locate and remove the AIR BAG fuse from the body control module fuse center.
- Remove the garnish molding from the upper lock pillar. Refer to Garnish Molding Replacement - Rear Upper in Interior Trim.
- Remove the connector position assurance (CPA) from the roof rail module - left connector.
- Disconnect the roof rail module - left connector from the vehicle harness connector.
IMPORTANT:
With the AIR BAG fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.