Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: The SIR system should be disabled before removal of the inflator. The inflator must be disposed of properly. All interior garnish molding snap-in clips must be replaced when the trim is removed from the vehicle. Twisting of the inflator must not be allowed.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2Β  or to SIR Disabling and Enabling Zone 6Β .
  2. Remove the headliner from the vehicle. Refer to Headliner Replacement (Wagon) or Headliner Replacement (Sedan) in Interior Trim.
  3. Fig 1: Removing/Installing Inflatable Restraint Roof Rail Module - Sedan
    GM897999Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.