SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM - 3.9L - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
    Fig 1: Identifying Throttle Body Assembly
    GM1582015Courtesy of GENERAL MOTORS CORP.
  1. Install a new gasket, if necessary.
  2. Install the throttle body.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body bolts/studs.

    Tighten:  Tighten the bolts/studs to 10 N.m (89 lb in).

  4. Position the heater inlet and outlet pipes and install the pipe bracket to the throttle body studs.
  5. Install the heater inlet and outlet pipe nuts (1).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    6. Fig 2: Identifying Electrical Connectors
    GM1581869Courtesy of GENERAL MOTORS CORP.
  6. Connect the ETC electrical connector (2).
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  8. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.