SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBRAKESANTILOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMREPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE (BPMV) BRACKET REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
    Fig 1: View Of 4 Insulator Bolts That Attach BPMV To Bracket
    GM1235535Courtesy of GENERAL MOTORS CORP.
  1. Install the bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 insulator bolts.

    Tighten:  Tighten the bolts to 10 N.m (86 lb in).

    3. Fig 2: View Of 3 Nuts Attaching Electronic Brake Control Module (EBCM)/Brake Pressure Modulator Valve (BPMV)
    GM1234790Courtesy of GENERAL MOTORS CORP.
  3. Install the 3 nuts that attach the bracket to the left front wheelhouse.

    Tighten:  Tighten the nuts to 10 N.m (86 lb in).

  4. Install the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.