SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBRAKESANTILOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESTRACTION OFF INDICATOR INOPERATIVETEST DESCRIPTION
2006 Pontiac G6 GTP, 2D Coupe, Standard

Test Description

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Test Description

The number below refers to the step number on the diagnostic table.

  1. 6:  This step tests if the instrument panel cluster (IPC) is able to turn ON the Traction Off indicator.
Traction Off Indicator Inoperative

Step Action Yes No
Schematic Reference: ABS Schematics 
Connector End View Reference: ABS Connector End Views  or Instrument Panel, Gages, and Console Connector End Views in Instrument Panel, Gages, and Console
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Traction Off indicator.
Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?		 Go to Diagnostic Aids  Go to Step 3 
3
  1. Disconnect the harness connector of the traction control system (TCS) switch.
  2. Ground the TCS signal circuit at the TCS harness connector.
Does the Traction Off indicator illuminate?		 Go to Step 4  Go to Step 5 
4 Replace the TCS switch. Refer to Traction Control Switch Replacement .
Did you complete the replacement?		 Go to Step 9  -
5 Test for an open in the TCS switch signal circuit. Refer to Circuit Testing in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 6 
6 
  1. Install a scan tool.
  2. Select the Instrument Panel Cluster (IPC) Special Functions menu on the scan tool.
  3. Command the IPC lamps ON.
Does the Traction Off indicator turn ON?		 Go to Step 8  Go to Step 7 
7 Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 9  -
8 Replace the body control module (BCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 9  -
9
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Traction Off indicator.
Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?		 System OK Go to Step 2 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.