Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSSTATIONARY WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD REVEAL MOLDING REPLACEMENTREMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Removal Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
IMPORTANT:
The window reveal molding is an applied molding design that is separate from the window. The reveal molding may be replaced with the window as an assembly, or the reveal molding may be available as a separate part. The window molding can only be replaced by removing the window. The old molding can not be reused.
- Remove the windshield. Refer to Windshield Replacement .
- Place the window on a clean prepared surface.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.