Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
Battery positive voltage is supplied through the BATT 1 fuse in the underhood fuse block to the rear defog relay switched input. When the rear defog switch button is pressed, the body control module (BCM) energizes the rear defog relay by providing a B+ to the control circuit of the rear defog relay. This allows battery positive voltage from the relay switched input through the switch contacts and out the relay switched output to the rear window defogger grid. The HVAC control module houses the rear defog switch and also illuminates the rear defog indicator on the switch button, upon this request. Ground for the rear window defogger grid is provided by G301 for the Sedan or G302 for the Extended Sedan.
When you start the engine and press the rear defog switch button, the defog cycle lasts for 10 minutes. Further operation will result in 5 minute defog cycles.
The rear defogger feature will not time out if vehicle speed is above 48 km/h (30 mph).
If battery voltage is low, the rear defogger feature will be disabled.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.