Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSSTATIONARY WINDOW SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B0283COMPONENT TESTINGDEFOG INDICATOR (C60 MANUAL A/C ONLY)
2006 Pontiac G6 GTP, 2D Coupe, Standard
Defog Indicator (C60 Manual A/C only)
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Defog Indicator (C60 Manual A/C only)
- Ignition OFF, disconnect the harness at the HVAC control module.
- Install a 5-amp fused jumper wire between circuit terminal B5 and 12 volts. Install a jumper wire between the ground circuit terminal A12 and ground. Verify the defog indicator illuminates. => If the defog indicator does not illuminate, replace the HVAC control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.