Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESPOWER WINDOWS INOPERATIVE - LOCKOUT FUNCTION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Power Windows Inoperative - Lockout Function
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Power Windows Inoperative - Lockout Function
Power Windows Inoperative - Lockout Function
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Power Window Schematics Connector End View Reference: Power Door Systems Connector End Views |
|||
| 1 | Did you perform the Vehicle Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Verify that the power windows lockout function is inoperative. Does the power windows lockout function operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Repair the short to voltage in the power window master switch lockout signal circuit. Refer to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 5 |
| 5 | Inspect for a poor connections at the harness connector of the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 6 | Replace the driver window switch. Refer to Power Window Switch Replacement - Left Front . Did you complete the replacement? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.