Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSPOWER STEERING CONTROL MODULE PROGRAMMING AND SETUPSTEERING TUNING SELECTION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Steering Tuning Selection
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Steering Tuning Selection
- Install the scan tool.
- Turn ON the ignition, with the engine OFF.
- With the scan tool select Special Functions
- Select Steering Tuning Selection and press the enter key. The scan tool screen will flash Selection in Progress then display Calibration Complete.
- Press the exit key.
- Use the scan tool in order to clear the DTCs.
- Turn OFF the ignition.
IMPORTANT:
After turning OFF the ignition, allow 25 seconds of wait time before performing any procedures that require the vehicles battery to be disconnected, or module memory loss may occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.