Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2005VIBE FWD L4-1.8L VIN 8REPAIR AND DIAGNOSISSTARTING AND CHARGINGTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2005 Pontiac Vibe FWD L4-1.8L VIN 8
Scan Tool Data Definitions
2005 Pontiac Vibe FWD L4-1.8L VIN 8SECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
PNP Switch: This parameter indicates the range selection of 3 speed or 4 speed automatic transmission equipped vehicles. The parameter will display Park/Neutral for the Park or Neutral position of the gear selector. The parameter will display In Gear for the Reverse, Drive, or Low positions of the gear selector.
Starter Switch: This parameter displays ON when the powertrain control module (PCM) is receiving a signal indicating that the engine starter motor is cranking.
PNP Switch: This parameter indicates the range selection of 3 speed or 4 speed automatic transmission equipped vehicles. The parameter will display Park/Neutral for the Park or Neutral position of the gear selector. The parameter will display In Gear for the Reverse, Drive, or Low positions of the gear selector.
Starter Switch: This parameter displays ON when the powertrain control module (PCM) is receiving a signal indicating that the engine starter motor is cranking.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.