Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSPONTIAC2005SUNFIRE L4-2.2L VIN FREPAIR AND DIAGNOSISTECHNICAL SERVICE BULLETINSCUSTOMER INTERESTA/T - 4T65E FLUID LEAKING FROM A/T VENT
2005 Pontiac Sunfire L4-2.2L VIN F
A/T - 4T65E Fluid Leaking From A/T Vent
2005 Pontiac Sunfire L4-2.2L VIN FSECTION A/T - 4T65E Fluid Leaking From A/T Vent
TECHNICAL
Bulletin No.: 01-07-30-032E
Date: September 29, 2008
Subject:
Transmission Oil Leaking From Transmission Vent (Replace Transmission Case Cover (Channel Plate) Gasket)
Models:
1997-2009 GM Passenger Cars and Light Duty Trucks (including Saturn)
with Hydra-Matic 4T65-E Automatic Transmission (RPOs MN3, MN7, M15, M76)
Supercede:
This bulletin is being revised to add the 2008 and 2009 model years. Please discard Corporate Bulletin Number 01-07-30-032D (Section 07 - Transmission/Transaxle).
Condition
Some customers may comment on a transmission oil leak.
Cause
This condition may be caused by an improperly torqued channel plate gasket.
Correction

To correct this condition, replace the case cover (channel plate) gaskets (429 and 430). Refer to Unit Repair publication in SI of the appropriate vehicle being serviced.
Visual inspection of the upper gasket (1) will reveal damage at the referenced area.

Parts Information
Warranty Information

For vehicles repaired under warranty, use the table.

Disclaimer
Bulletin No.: 01-07-30-032E
Date: September 29, 2008
Subject:
Transmission Oil Leaking From Transmission Vent (Replace Transmission Case Cover (Channel Plate) Gasket)
Models:
1997-2009 GM Passenger Cars and Light Duty Trucks (including Saturn)
with Hydra-Matic 4T65-E Automatic Transmission (RPOs MN3, MN7, M15, M76)
Supercede:
This bulletin is being revised to add the 2008 and 2009 model years. Please discard Corporate Bulletin Number 01-07-30-032D (Section 07 - Transmission/Transaxle).
Condition
Some customers may comment on a transmission oil leak.
Cause
This condition may be caused by an improperly torqued channel plate gasket.
Correction
To correct this condition, replace the case cover (channel plate) gaskets (429 and 430). Refer to Unit Repair publication in SI of the appropriate vehicle being serviced.
Visual inspection of the upper gasket (1) will reveal damage at the referenced area.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.