Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2005 Pontiac Montana SV6 AWDSECTION Installation Procedure
- Install the shift lock actuator (2) to the linear shift assembly.
- Install the shift lock actuator screws (3).
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Connect the shift lock actuator electrical connector (1).
- Rotate the linear shift assembly (2) up to align the linear shift assembly bolt holes.
- Install the linear shift front bolts (2).
Tighten: Tighten the bolts (1, 2) to 10 N.m (89 lb in).
- Install the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
- Install the trim covers to the steering column. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.