Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2005MONTANA SV6 AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLE
2005 Pontiac Montana SV6 AWD
Instrument Panel System Displays, Gauges And Console
2005 Pontiac Montana SV6 AWDSECTION Instrument Panel System Displays, Gauges And Console
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Instrument Panel, Gages and Console
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B0160
- DTC B0161
- DTC B0931
- DTC B0935
- DTC B1000
- DTC B1327
- DTC B1328
- DTC P0462
- DTC P0463
- DTC P0464
- Symptoms - Instrument Panel, Gages and Console
- Engine Coolant Temperature Gage Inaccurate or Inoperative
- Fuel Gage Inaccurate or Inoperative
- Speedometer and/or Odometer Inaccurate or Inoperative
- Tachometer Inaccurate or Inoperative
- Change Engine Oil Indicator Always On
- Change Engine Oil Indicator Inoperative
- Engine Oil Pressure Indicator Always On
- Low Fuel Indicator Inoperative
- Driver Information Center (DIC) Switch(es) Inoperative
- Chime Always On
- Chime Inoperative
- Repair Instructions
- Knee Bolster, Insulator, Molding Replacement - Instrument Panel
- Accessory Trim Plate, Driver Information Display Switch Replacement - Instrument Panel
- Compartment Assembly, Door, Striker, Latch Replacement - Instrument Panel
- Carrier Cover, Accessory Trim Panel Lower Extension Replacement - Instrument Panel
- Cluster, Cluster Trim Plate Replacement - Instrument Panel
- Upper Trim Pad, Outer Trim Cover, Fuse Block Access Cover Replacement - Instrument Panel
- Cup Holder, Cup Holder Door Replacement - Front Floor Console
- Compartment, Door, Latch, Panel, Mat Replacement - Front Floor Console (Base)
- Compartment, Door, Latch, Panel, Mat Replacement - Front Floor Console (Uplevel)
- Bracket, Reinforcement, Side Trim Panel Replacement - Front Floor Console
- Ambient Air Temperature Gage Sensor Replacement
- Electronic Compass Calibration
- Instrument Panel (I/P) Assembly Replacement
- Instrument Panel (I/P) Carrier Replacement
- Instrument Panel (I/P) Harness Replacement
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.