Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Position Sensor Calibration
After replacement of the automatic level control sensor, the system untested code will be displayed by a continuous flashing accessory inflator switch LED with a repetition rate of 0.25 second. The self test will need to be performed and a code 12 system OK will have to be displayed on the accessory inflator switch LED before the system can function normally. Refer to Diagnostic Trouble Code (DTC) Displaying in Automatic Level Control for instructions to perform ALC self test.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.