Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2005GRAND PRIX V6-3.8L SC VIN 4REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLPARKING BRAKE SYSTEMPARKING BRAKE WARNING SWITCHSERVICE AND REPAIR
2005 Pontiac Grand Prix V6-3.8L SC VIN 4
Parking Brake Warning Switch: Service and Repair
2005 Pontiac Grand Prix V6-3.8L SC VIN 4SECTION Service and Repair
Park Brake Warning Lamp Switch Replacement
Removal Procedure
1. Remove the left side instrument panel insulator.
2. Remove the left carpet retainers.
3. Disconnect the electrical connector from the switch.
4. Remove the mounting screw.
5. Remove the parking brake indicator switch (1).
Installation Procedure
1. Install the parking brake indicator switch (1).
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the mounting screw.
Tighten the mounting screw to 3 Nm (26 inch lbs.).
3. Connect the electrical connector to the switch.Check the operation of the switch.
4. Install the left carpet retainers.
5. Install the left side instrument panel insulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.