Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Pontiac Montana Van PassengerSECTION Installation Procedure
- Install the inflator module wiring harness (3) to the driver seat frame, while guiding the wiring harness through the appropriate spots on the driver seat frame.
- Install the wiring harness retaining clips to the driver seat frame.
- Install the plastic molding (2) that holds the air bag inflator module to the driver seat back frame.
- Install the air bag inflator module (1) to the driver seat back frame.
- Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
- Install the driver seat. Refer to Seat Replacement - Bucket in Seats.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.